subject
Business, 05.12.2019 20:31 Dmoney7784

If your bank is a member of the fdic, what does that mean for you? a. the bank is not allowed to lend out your money. b. you will get a better exchange rate than at other banks. c. your bank is allowed to print out currency for you. d. your money is protected by insurance up to a specific amount.

ansver
Answers: 3

Another question on Business

question
Business, 22.06.2019 11:10
The prebisch–singer hypothesis concludes that: a. technology lowers the cost of manufactured products, so developing countries should see an increase in their terms of trade. b. developing countries experience a long-run decline in their terms of trade, as the demand for primary products in higher-income countries declines relative to their demand for manufactured goods. c. because of unfair trading practices, labor in developing countries is exploited. d. opec has been responsible for a slowdown in the world's standard of living.
Answers: 3
question
Business, 22.06.2019 12:50
Performance bicycle company makes steel and titanium handle bars for bicycles. it requires approximately 1 hour of labor to make one handle bar of either type. during the most recent accounting period, barr company made 7,700 steel bars and 2,300 titanium bars. setup costs amounted to $35,000. one batch of each type of bar was run each month. if a single company-wide overhead rate based on direct labor hours is used to allocate overhead costs to the two products, the amount of setup cost assigned to the steel bars will be:
Answers: 2
question
Business, 22.06.2019 19:30
Problem page a medical equipment industry manufactures x-ray machines. the unit cost c (the cost in dollars to make each x-ray machine) depends on the number of machines made. if x machines are made, then the unit cost is given by the function =cx+−0.3x2126x31,935 . how many machines must be made to minimize the unit cost?
Answers: 3
question
Business, 22.06.2019 21:50
Q3. loral corporation manufactures parts for an aircraft company. it uses a computerized numerical controlled (cnc) machining center to produce a specific part that has a design (nominal) target of 1.275 inches with tolerances of ± 0.020 inch. the cnc process that manufactures these parts has a mean of 1.285 inches and a standard deviation of 0.005 inch. compute the process capability ratio and process capability index, and comment on the overall capability of the process to meet the design specifications.
Answers: 1
You know the right answer?
If your bank is a member of the fdic, what does that mean for you? a. the bank is not allowed to le...
Questions
question
Mathematics, 19.03.2022 15:50
question
French, 19.03.2022 16:10
Questions on the website: 13722362