Process Output Analysis A shaft with specifications of Ø.500±.005 is being turned on a CNC turning center. Measurements were taken and recorded in the table below. Using this data create an Excel spreadsheet to perform all the necessary calculations to complete the process output analysis. Create a form, in excel, similar to this (Click Here). Enter data in yellow shaded cells and perform your calculations in the appropriate orange shaded cells. Password protect cells where a formula is performed (Ensure to include the password with your assignment so it can be marked). The spreadsheet should be fully automated using cell addresses in all calculations and not typed in answers. Create a histogram of the measurement data. Label process mean, USL, LSL, and process capability in the approximate spot on the histogram. Table of Sample Data Data 0.502 0.496 0.501 0.502 0.501 0.498 0.502 0.498 0.499 0.504 0.497 0.501 0.502 0.503 0.500 0.501 0.500 0.499 0.500 0.502 0.496 0.502 0.500 0.499 0.505 0.496 0.499 0.502 0.500 0.504 0.495 0.499 0.503 0.499 0.504 0.499 0.501 0.502 0.499 0.498 0.499 0.501 0.503 0.498 0.501 0.501 0.500 0.502 0.500 0.501 0.501 0.498 0.503 0.499 0.498 0.500 0.501 0.502 0.503 0.499 0.500 0.502 0.501 0.500 0.499 0.500 0.501 0.499 0.500 0.501 0.501 0.494 0.500 0.501 0.499 0.502 0.502 0.501 0.500 0.501 0.499 0.500 0.502 0.499 0.498 0.500 0.499 0.500 0.502 0.497 0.500 0.502 0.501 0.500 0.500 0.503 0.502 0.501 0.495 0.501 0.501 0.499 0.500 0.504 0.497 0.500 0.501 0.496 0.500 0.501 0.498 0.500 0.500 0.500 0.502 0.501 0.501 0.497 0.501 0.505 0.501 0.503 0.498 0.501 0.503 ASSIGNMENT WILL BE EVALUATED ON DATA PRESENTATION AND THE COMPLETENESS AND CORRECTNESS OF THE ASSIGNMENT REQUIREMENTS