Room attendants often work under a lot of pressure to clean a guest room within the allotted time and to the exacting standards set by the hotel. This would not be possible unless they followed a set procedure. When they report for work, room attendants receive assignments sheets that indicate the number of rooms they must clean along with the room status report. They always follow a specific procedure for cleaning. Given below are the steps involved in cleaning a guest room. Read these steps and then answer the following questions. (You can consult online articles on the subject to answer the questions.) Stock the housekeeping cart with cleaning supplies, linen, and guest supplies. Collect the assignment sheet, room status report, and room keys from the housekeeping supervisor. Review the room status report to determine the order in which to clean the rooms. Follow the set procedure when entering a guest room. Place the cleaning cart across the doorway. Turn on lights, open the drapes, and set the air conditioner. Stock room supplies, replace glasses, etc. Empty the trash. Dust the furniture. Vacuum the floor. Remove soiled linen. Make the beds. Check the room for lost and found articles. Restock all bathroom supplies. Clean the bathroom. Check that all appliances and equipment (such as the television, telephone, lighting, etc.) work properly. Inspect the room. Record any comments. Close drapes and spray air freshener. Part A Some of the tasks given above are not in the proper sequence. Arrange the tasks in the correct sequence and explain your reasons for the changes.

With q7 assume the sweet company uses a plantwide predetermined overhead rate with machine-hours as the allocation base.and for q 10,11,13,and 14,assume that the company use department predetermined overhead rates with machine-hours as the allocation bade in both departements.7. assume that sweeten company used cost-plus pricing (and a markup percentage of 80% of total manufacturing cost) to establish selling prices for all of its jobs. what selling price would the company have established for jobs p and q? what are the selling prices for both jobs when stated on a per unit basis assuming 20 units were produced for job p and 30 units were produced for job q? (do not round intermediate calculations. round your final answers to nearest whole dollar.)total price for the job for job p -job q selling price per unit for job p q . how much manufacturing overhead was applied from the molding department to job p and how much was applied to job q? (do not round intermediate calculations.) job p job q manufacturing overhead applied for job p for job q . how much manufacturing overhead was applied from the fabrication department to job p and how much was applied to job q? (do not round intermediate calculations.)job p job q manufacturing overhead applied for job p for job q . if job q included 30 units, what was its unit product cost? (do not round intermediate calculations. round your final answer to nearest whole dollar.)14. assume that sweeten company used cost-plus pricing (and a markup percentage of 80% of total manufacturing cost) to establish selling prices for all of its jobs. what selling price would the company have established for jobs p and q? what are the selling prices for both jobs when stated on a per unit basis assuming 20 units were produced for job p and 30 units were produced for job q? (do not round intermediate calculations. round your final answer to nearest whole dollar.)total price for the job p for job q selling price per unit for job p for job q