Economic which of these is most likely a result of a high unemployment rate in the united states? a) increased revenues b) increased demand for consumer goods c) increased production of capital goods d) greater government expenditures for transfer payments

Miko willingly admits that she is not an accountant by training. she is concerned that her balance sheet might not be correct. she has provided you with the following additional information. 1. the boat actually belongs to miko, not to skysong, inc.. however, because she thinks she might take customers out on the boat occasionally, she decided to list it as an asset of the company. to be consistent, she also listed as a liability of the corporation her personal loan that she took out at the bank to buy the boat. 2. the inventory was originally purchased for $27,500, but due to a surge in demand miko now thinks she could sell it for $39,600. she thought it would be best to record it at $39,600. 3. included in the accounts receivable balance is $11,000 that miko loaned to her brother 5 years ago. miko included this in the receivables of skysong, inc. so she wouldn’t forget that her brother owes her money. (b) provide a corrected balance sheet for skysong, inc.. (hint: to get the balance sheet to balance, adjust stockholders’ equity.) (list assets in order of liquidity.)

Performance bicycle company makes steel and titanium handle bars for bicycles. it requires approximately 1 hour of labor to make one handle bar of either type. during the most recent accounting period, barr company made 7,700 steel bars and 2,300 titanium bars. setup costs amounted to $35,000. one batch of each type of bar was run each month. if a single company-wide overhead rate based on direct labor hours is used to allocate overhead costs to the two products, the amount of setup cost assigned to the steel bars will be:

Statistical process control charts: a. indicate to the operator the true quality of material leaving the process. b. display upper and lower limits for process variables or attributes and signal when a process is no longer in control. c. indicate to the process operator the average outgoing quality of each lot. d. display the measurements on every item being produced. e. are a graphic way of classifying problems by their level of importance, often referred to as the 80-20 rule.