Chemistry, 23.08.2019 12:30 jonathankingsberry52

Which scientist is known for developing the planetary model of the atom?
niels bohr
albert einstein
johannes rydberg
robert millikan

Answers: 1

Show answers

Answers

Answer from: emma650

Niels Bohr. The Bohr model is one of the most famous models, if not the most famous. It's the easiest one to draw, but the current model of the atom--the quantum mechanical model--builds upon it.

Answer from: Quest

assuming that your periodic table has eighteen columns, you should highlight the four elements in the third column from the left of the table.

explanation

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the $3d$ have energy higher than those in the $4 s$ orbital while lower than those of the $4 p$ orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the $4s$ orbital is therefore filled right after $3p$ orbitals and before $3 d$ orbitals.

potassium has electron configuration $[\text{ar}] 4 s^{1}$ and calcium $[\text{ar}] 4 s^{2}$ . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration $[\text{ar}] 4 s^{2} \; 3d^{1}$ and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the $ns^{2} \; (n-1) p^{1}$ and should be highlighted as well.

Answer from: Quest

when the volume of gas is changed from 717.73 ml to 852 ml the temperature will change from 315 c to 452 c

calculation

this is calculated using the charles law formula

that is, v1/t1 = v2/t2

v1=?

t1 = 315 c into kelvin = 315 +273 = 588 k

v2 = 852 ml

t2 = 425c + 273 =698 k

make v1 the subject of the formula ( by multiplying both side by t1)

v1=( v2 xt1) / t2

v1= (852 ml x 588 k)/ 698 k= 717.73 ml

Another question on Chemistry

Chemistry, 22.06.2019 13:30

How many moles is 14.5 cm^3 of platinum? the density of platinum is 21.45 g/cm^3.

Answers: 1

Answer

Chemistry, 23.06.2019 12:20

Amatch has about 21 milligrams of red phosphorus coating the tip. how many atoms of phosphorus is this?

Answers: 1

Answer

Chemistry, 23.06.2019 15:30

You can smell perfume because of which change of state

Answers: 1

Answer

Chemistry, 23.06.2019 19:00

Freya built a model of the earth, sun, and moon. freya can cause her model to move in three different ways. she can turn the crank to model how the earth revolves around the sun, she can spin the globe to model how the earth rotates on its axis, and she can push the moon with her fingers to model how the moon revolves around the earth. how could freya best use her model to demonstrate the cause of the day/night cycle on earth?

Answers: 1

Answer

You know the right answer?

Which scientist is known for developing the planetary model of the atom?
niels bohr
alb...

Questions