Chemistry, 25.09.2019 03:00 ianukog2481

Awater main made out of galvanized iron has an inner pipe diameter of 0.1 meters, an inlet pressure of 1000 kpa, outlet pressure of 500 kpa, water flow rate of 5 m3/min, and 10 90 degree elbows. what length galvanized iron line should be used to reach the desired outlet pressure?

Answers: 1

Show answers

Another question on Chemistry

Chemistry, 22.06.2019 03:00

Which of the dna typing techniques do you think you would choose if you had to analyze a dna sample? why?

Answers: 1

Answer

Chemistry, 22.06.2019 11:00

Freezing and boiling are endothermic processes. this means that these processes absorb energy from their surroundings in order to occur. use this information and the data you collected in the phase change gizmo to describe what happens to the temperature of water when you boil it, then explain why this result occurs.

Answers: 1

Answer

Chemistry, 22.06.2019 18:30

Two people each hold the end of a rope and create waves by moving their arms up and down. this wave is best classified as a transverse wave because a) both the rope particles and the wave are moving in the same direction. b) the wave is moving up and down as the particles of the rope move horizontally. c) the wave is moving horizontally as the particles of the rope move up and down. eliminate d) the wave is moving in a parallel direction with the motion of the person's arms.

Answers: 3

Answer

Chemistry, 23.06.2019 02:50

For questions 1 and 2, consider the following experimental data.hydrogen emission lines were detected at the following wavelengths (in nm): 121.6102.697.395.093.8question 1use the electromagnetic radiation classifications below and figure 1-1 in the introductory information for this lab (in the lab manual) to determine the nf value for the experimental data provided? wavelength, ? (nm) 650 700 550 600 400 450 500 visible spectrum wavelength, ? (m) 11 10 3 10 10 10 8 10 5 10 10 -10 10 9 10 10 10 10 -12 10 microwave radio infrared x-ray ultraviolet gamma 1020 1019 1018 1 1016 015 1014 01 12 109108 frequency, v (hz)a.1b. 2c. 3d. 4e. 5question 2using the data for the emission line with the longest wavelength, the known value of nf (from question 1 in this prelab), and the value of ni (deduced from the ? and nf values) calculate the rydberg constant for hydrogen (rh) in units of m-1.a) 1.097 x 10-11 m-1b) 5.921 x 107 m-1c) 1.097 x 10-2 m-1d) 9.252 x 106 m-1e) 1.097 x 107 m-1

Answers: 3

Answer

You know the right answer?

Awater main made out of galvanized iron has an inner pipe diameter of 0.1 meters, an inlet pressure...

Questions