Chemistry, 14.01.2020 21:31 nmg9

After completing an experiment to determine gravimetrically the percentage of water in a hydrate, a student reported a value of 38 percent. the correct value for the percentage of water in the hydrate is 51 percent. which of the following is the most likely explanation for this difference. a. strong initial heating caused some of the hydrate sample to spatter out of the crucibleb. the dehydrated sample absorbed moisture after heatingc. the amount of the hydrate sample used was too smalld. the crucible was not heated to constant mass before usee. excess heating caused the dehydration sample to decompose

Answers: 1

Show answers

Another question on Chemistry

Chemistry, 22.06.2019 04:30

Suppose that during that icy hot lab 65,000 j of energy were transferred to 450 g of water at 20°c what would have have been the final temperature of the water

Answers: 2

Answer

Chemistry, 22.06.2019 05:30

A3.37-mg sample of protein was chemically digested to convert its nitrogen into ammonia and then diluted to 100.0 ml. then 10.0 ml of this solution was placed in a 50-ml volumetric flask and treated with 5 ml of phenol solution plus 2 ml of sodium hypochlorite solution. the sample was diluted to 50.0 ml, and the absorbance at 625 nm was measured in a 1.00-cm cuvette and found to be 0.486. for reference, a standard solution was prepared from 10.0 mg of nh4cl (molar mass = 53.49 grams/mole) dissolved in 1.00 l of water. then 10.0 ml of this standard was placed in a 50-ml volumetric flask, treated in the same manner as the unknown, and the absorbance found to be 0.323. finally, a reagent blank was prepared using distilled water in place of unknown, it was treated in the same manner as the unknown, and the absorbance found to be 0.076. calculate the weight percent of nitrogen in the protein.

Answers: 1

Answer

Chemistry, 22.06.2019 05:40

Can someone me with 1 to 4 plz. fast

Answers: 1

Answer

Chemistry, 22.06.2019 15:00

Large helium-filled balloons are used to lift scientific equipment to high altitudes. what is the pressure inside such a balloon if it starts out at sea level with a temperature of 10.0ºc and rises to an altitude where its volume is twenty times the original volume and its temperature is – 50.0ºc ?

Answers: 2

Answer

You know the right answer?

After completing an experiment to determine gravimetrically the percentage of water in a hydrate, a...

Questions