Chemistry, 25.03.2020 22:27 farihasy6508

Calculate the pH of a solution with a [H3O+] concentration of 3.0 x 10-9 M.

Answers: 3

Show answers

Another question on Chemistry

Chemistry, 21.06.2019 15:30

If 200.0g of copper(ll) sulfate react with an excess of zinc metal, what is the theoretical yield of copper

Answers: 1

Answer

Chemistry, 22.06.2019 00:40

Base your answer on the information below and on your knowledge of chemistry. nitrogen dioxide, no2, is a dark brown gas that is used to make nitric acid and to bleach flour. nitrogen dioxide has a boiling point of 294 k at 101.3 kpa. in a rigid cylinder with a movable piston, nitrogen dioxide can be in equilibrium with colorless dinitrogen tetroxide, n2o4. this equilibrium is represented by the equation below. 2no2(g) n2o4(g) + 58kj at standard pressure, compare the strength of intermolecular forces in no2(g) to the strength of intermolecular forces in n2(g).

Answers: 2

Answer

Chemistry, 22.06.2019 04:00

Seltzer water is created by placing water under pressure with carbon dioxide gas. which of the following statements best describe seltzer water: a. the solution will be slightly acidic b. the solution will be slightly basic. the solution will be strongly acidic. d. the solution will be strongly basic. e. the solution will be neutral

Answers: 3

Answer

Chemistry, 22.06.2019 13:00

These questions are based on the attached photo. the experiment is about burning magnesium metal with oxygen. 1. write the balanced chemical equation for the reaction you are performing. 2. calculate the mass of magnesium metal used in each trial. o trial 1: o trial 2: 3. calculate the actual yield of magnesium oxide for each trial. o trial 1: o trial 2: 4. magnesium is the limiting reactant in this experiment. calculate the theoretical yield of mgo for each trial. o trial 1: o trial 2: 5. determine the percent yield of mgo for your experiment for each trial. o trial 1: o trial 2: 6. determine the average percent yield of mgo for the two trials. your company currently uses a process with a similar cost of materials that has an average percent yield of 91 percent. if the average percent yield of this process is higher than that, this could save the company money. what is your recommendation to the company? support your recommendation using your data, calculations, and understanding of stoichiometry gathered from this lab.

Answers: 1

Answer

You know the right answer?

Calculate the pH of a solution with a [H3O+] concentration of 3.0 x 10-9 M....

Questions