Chemistry, 15.04.2020 17:40 suewignall

You are a researcher with an interest in understanding the mechanism of serine protease enzymes. To test the effect of the role of Asp102 in the efficiency of catalysis, you make targeted substitutions of that residue and compare the rate of hydrolysis of p-nitrophenyl acetate with the rate on the unmutated enzyme. Answer the following questions: a. (4) You observe a bi-phasic plot, i. e. a quick burst of product (p-nitrophenol) release (seen as a steep curve), followed by a slower (less steep) curve. What step of the reaction corresponds to each phase of the chymotrypsin reaction? And which corresponds to the Michaelis-Menten Steady State? Explain. b. (4) If you mutate Asp102 to create an enzyme with Asn102, describe (or draw) changes you would expect to see in p-nitrophenol release – and, of course, explain your answer. c. (4-8) For the wild type (unmutated) enzyme, you measure a rate of p-nitrophenol release by the change in absorbance at 405 nm (for the slower phase only) of 0.216 (in a cuvette with a pathlength of 1 cm) over the course of two minutes. Use the Beer-Lambert Law to calculate the concentration of product released over this time; the extinction coefficient of p-nitrophenol at 405 nm is 18,000 M-1 cm-1. For extra credit: If your assay is done with 1 x 10-9 M enzyme, what is the turnover number for this enzyme?

Answers: 1

Show answers

Another question on Chemistry

Chemistry, 22.06.2019 05:00

Choose all the answers that apply. ionic compounds dissolve easily in water do not dissolve in water have low melting points have high melting points conduct electricity when melted

Answers: 1

Answer

Chemistry, 22.06.2019 05:30

A3.37-mg sample of protein was chemically digested to convert its nitrogen into ammonia and then diluted to 100.0 ml. then 10.0 ml of this solution was placed in a 50-ml volumetric flask and treated with 5 ml of phenol solution plus 2 ml of sodium hypochlorite solution. the sample was diluted to 50.0 ml, and the absorbance at 625 nm was measured in a 1.00-cm cuvette and found to be 0.486. for reference, a standard solution was prepared from 10.0 mg of nh4cl (molar mass = 53.49 grams/mole) dissolved in 1.00 l of water. then 10.0 ml of this standard was placed in a 50-ml volumetric flask, treated in the same manner as the unknown, and the absorbance found to be 0.323. finally, a reagent blank was prepared using distilled water in place of unknown, it was treated in the same manner as the unknown, and the absorbance found to be 0.076. calculate the weight percent of nitrogen in the protein.

Answers: 1

Answer

Chemistry, 22.06.2019 06:00

In an investigation that uses the scientific method, which step immediately follows making a hypothesis? o summarizing the results o asking a question o making observations designing an experiment mark this and retum save and exit next submit

Answers: 2

Answer

Chemistry, 22.06.2019 07:30

How many atoms are there in 5.70 mol of mg

Answers: 1

Answer

You know the right answer?

You are a researcher with an interest in understanding the mechanism of serine protease enzymes. To...

Questions