You arrive at a crime scene and are told the body of the victim is at the bottom of a pool that is 10 m deep. You walk over to what you are told is a 12 m in diameter, cylindrical pool. From the outside of the pool, you can see that the body looks badly burnt. Your partner says, “It looks like our victim had been burned alive and tried to put out the fire by jumping in the pool. The victim likely drowned to death.” Something does not sit right with you though. If there was a fire, where did it start? There are no signs of combustion anywhere. You aren’t so sure and ask the crime scene investigator to run a sample of the pool water before letting anybody try to pull the body out. The CSI comes back to you and tells you that normal pool water pH is roughly around 7.2, but the pool pH is actually highly basic at a level of 13, with a concentration of hydroxide ions at 1.0 x 10-1 mol/L. It becomes obvious to you that the body wasn’t burned before going in to the pool, but AFTER, and there was no fire needed! You order the body to be removed from the pool, but the CSI interjects, “It would be too dangerous with a pH that high. I suggest you get some vinegar from the store and pour it in to the pool beforehand to drop the pH to 7. Draining the pool would take far too long and we need to examine the body as soon as possible.” She asks one of your constables to go to the store to purchase five 4L jugs of vinegar (pH = 2) to pour in the pool, as she states it is enough to bring the pH to a safe level of 7. It sounds like it could be enough vinegar based on your knowledge of acids and bases, but you want to double-check her estimate before sending your constable to the store. Verify whether or not she is correct using calculations. A diagram may help you with your calculations. Hint 1: 1m3 = 1000L Hint 2: Vcylinder = πr2h

The vinegar is not enough to neutralize the pool.

Explanation:

The [OH⁻] in the pool is 1.0x10⁻¹mol / L. To know how many moles of OH⁻ are in the solution, you must calculate volume of the pool thus:

V(pool) = πr²h

Where radius is d/2 = 12m/2 = 6m

and h is deep of the pool = 10m

V(pool) = π(6m)²*10

V(pool) = 1131m³

As 1m³ = 1000L:

1131000L in the pool. And moles of OH⁻ are:

1.0x10⁻¹mol / L ₓ 1131000L = 131100 moles of OH⁻ are in the pool

The neutralization of OH⁻ with H⁺ is:

OH⁻ + H⁺ → H₂O

To neutralize the pool you must add 131100 moles of H⁺.

The H⁺ concentration in a vinegar pH = 2 is:

pH = -log [H⁺]

2 = -log [H⁺]

1x10⁻²M = [H⁺]

4L are just 4x10⁻² moles of [H⁺]. That means:

but know think of it in terms of bond breaking and bond making.

h–h + h–h + o=o ==> h–o–h + h–o–h

as you can see from the diagram, theoretically, more energy is released by forming water, than was absorbed in breaking up the original hydrogen and oxygen molecules.

the energy level of the fuel + oxygen is higher than that of water.

therefore the fuel + oxygen mixture has the potential to release potential chemical energy as heat energy or, crucially, electrical energy, if the reaction can be made to go via  oxidation and reduction reactions involving electron transfer.

see this page for more details of the full  bond energy calculations

a  fuel cell  is a device to make electricity that functions like an electrical cell or battery that you supply with a fuel (liquid or gas) and an oxidant (oxidising agent, usually oxygen gas) which react together in a redox reaction (oxidation + reduction) to release energy as a flow of electrons i.e. an electrical current capable of doing useful work.

the oxidation of the fuel and the reduction of the oxidant reactions take place on electrodes (see diagram on right, all fully explained further down the page).

fuel cells essentially a device to release the chemical potential energy of combustible fuels as electrical energy  at a much lower temperature and without the flame!

so, the idea of a  hydrogen–oxygen fuel cell  is to release the energy from hydrogen reacting with oxygen, not as heat as in normal combustion in air, but as  useful electrical energy  i.e. a practical electricity supply.

hydrogen-oxygen fuel cells are much efficient than conventional power stations or batteries (e.g. zinc-carbon) because the electrical energy is directly generated from the chemical reaction between the oxidant and the fuel - there are no complications with boilers, turbines and generators.

in fossil fuel power stations, motor vehicles, coal/gas fires etc. quite a percentage of energy is lost as waste heat.

with a fuel cell there are fewer stages in producing the useful energy, so there is less opportunity to lose potentially useful energy e.g. waste heat, friction from moving parts etc.

a hydrogen–oxygen fuel cell is a non–polluting clean fuel since the only combustion product is water.

fuel cells  do not produce pollutants like carbon monoxide, sulfur dioxide and nitrogen oxides - gases you get from fossil fuel combustion in power stations or burnt road vehicles..

cars powered by fuel cells would be quite an environmental advantage in cities, where electric cars are already beginning to be significantly used in developed countries.

fuel cells could replace larger batteries which are not easily recycled and contain highly toxic metal compounds.

it would be an ideal fuel on this basis e.g. for motor vehicles, but that's not the only factor to consider!

it would be ideal if the hydrogen fuel could be manufactured by electrolysis of water e.g. using solar cells.

hydrogen can be used to power fuel cells.

it all sounds wonderful but, still technological problems to solve for large scale manufacture and distribution of 'clean' hydrogen gas or use in generating electricity and its rather an inflammable explosive gas!

explanation:

fuel cells e.g. the hydrogen-oxygen fuel electrical cell

fuel cells have to be supplied by an external source of fuel (e.g. hydrogen) and an oxidant e.g. oxygen or air.

the hydrogen or any other fuel is oxidised electrochemically inside the fuel cell to produce a potential difference i.e. a voltage capable of producing a working current.

the overall chemical reaction in a hydrogen fuel electrochemical cell involves the oxidation of hydrogen by oxygen to produce only water.

hydrogen fuel cells offer an alternative to rechargeable cells and batteries.

a fuel cell will produce a potential difference  ('voltage')  and a workable electric current until one of the reactants is used up.

hydrogen gas can be used as fuel.

it burns with a pale blue flame in air reacting with oxygen to be oxidised to form water.

hydrogen + oxygen  ==>   water

2h2(g)  + o2(g)  ==>   2h2o(l) 

atomic number of carbon is 6

electronic configuration of carbon is 1s²2s²2p²

orbital diagram of c is as shown here in the image.