Chemistry, 08.12.2020 05:50 potatogirl6811

Using the data in Table 1, and the fact that the total volume of the reaction mixture in each case was 100. mL, fill in the concentration columns for [I-] and [S2O82-] in Table 2. Knowing that except for zero-order reactions the rate of a chemical reaction changes over the course of the reaction, and that the average rate can be defined as the time taken for the completion of the whole experiment and is inversely proportional to the time taken (half the time means twice the rate), fill in the three columns for the average rate below. (Just take your time from Table 1 and put it under 1 ⇒ 1/time = 1/s = sec-1)

Using the data in Table 1, and the fact that the total volume of the reaction mixture in each case

Answers: 2

Show answers

Another question on Chemistry

Chemistry, 21.06.2019 23:50

2points why do scientists need governmental funding? o a. government politicians ask all the important scientific questions. o b. scientists have to pay taxes to the government on the money they make. o c. the cost of doing scientific research can be very high. o d. the government is controlled by scientists. submit

Answers: 3

Answer

Chemistry, 22.06.2019 06:30

The following reaction shows the products when sulfuric acid and aluminum hydroxide react. al(oh)3 + h2so4 → al2(so4)3 + h2o the table shows the calculated amounts of reactants and products when the reaction was conducted in a laboratory. sulfuric acid aluminum hydroxide initial amount of reactant 40 g 15 g theoretical yield of water from reactant 14.69 g 10.38 g what is the approximate amount of the leftover reactant? 11.73 g of sulfuric acid 10.33 g of sulfuric acid 11.12 g of aluminum hydroxide 13.67 g of aluminum hydroxide

Answers: 3

Answer

Chemistry, 22.06.2019 14:30

Connect the whole numbers on the periodic table to indicate what they represent?

Answers: 3

Answer

Chemistry, 22.06.2019 18:00

Answer asap need it by wednesday morning carry out the following calculations on ph and ka of from data. i. calculate the ph of 0.02m hcl ii. calculate the ph of 0.036m naoh iii. calculate the ph of 0.36m ca(oh)2 iv. calculate the ph of 0.16m ch3cooh which has ka = 1.74 x 10-5 mol dm-3 v. calculate ka for weak acid ha which has a ph of 3.65 at 0.30m concentration vi. calculate the ka of a solution made by mixing 15.0 cm3 0.2m ha and 60.0 cm3 0.31m a-. [ph= 3.80] vii. calculate the ph of a solution made by mixing 15.0 cm3 0.1m naoh and 35.0 cm3 0.2m hcooh. [ka = 1.82 x 10-4 m]

Answers: 1

Answer

You know the right answer?

Using the data in Table 1, and the fact that the total volume of the reaction mixture in each case w...

Questions