Question: Explain how each of the three types of energy transfer occurs in a solar oven while it cooks a bowl of soup. Read below for some ideas of the answer and if you answer please make your answer reasonable.

To remove a metal pan from a hot oven, you must use an insulated pad or glove. If you do not, energy will transfer quickly to your hand by conduction. The pan is much hotter than your skin, so its particles have a lot more thermal energy. When the particles of the metal bump into the particles of your skin, energy is transferred.

When the hot pan is on top of the stove, you can tell that it is hot by holding your hand above the pan. The moving air around the pan absorbs energy and carries it to your skin by convection. You can also absorb energy by holding your hand to the side of a stove’s heating element. Energy is transferred through radiation to your skin.

Energy in the form of heat can be transferred by conduction, convection, and radiation. During all three types of energy transfer, the thermal energy of the warmer object decreases and the thermal energy of the cooler object increases. In all three types of energy transfer, energy is being transferred to a cooler object.

Converting light energy to heat energy: Solar cookers concentrate sunlight onto a receiver such as a cooking pan. The interaction between the light energy and the receiver material converts light to heat and this is called conduction. This conversion is maximized by using materials that conduct and retain heat.

Explanation:

i'm assuming that it's c.) red bank..

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.