Chemistry, 29.08.2019 02:30 alexislringler

Acar with a mass of 1.1 × 103 kilograms hits a stationary truck with a mass of 2.3 × 103 kilograms from the rear end. the initial velocity of the car is +22.0 meters/second. after the collision the velocity of the car is -11.0 meters/second. what is the velocity of the truck after this elastic collision?
a.+13 meters/second
b.+20 meters/second
c.+15.7 meters/second
d.+7.5 meters/second
e.+9.8 meters/second

Answers: 1

Show answers

Answers

The answer is C : 15.7 m/s
Use the idea of : momentum before collision = momentum after collision

Before collision;
For car:mass=1.1×10^3, velocity=22
For truck:mass=2.3×10^3, velocity=0
After collision;
For car:mass=2.3×10^3, velocity=-11
For truck:mass=2.3×10^3, velocity=V
(1.1×10^3 × 22) + (2.3×10^3 × 0) = (1.1×10^3 × -11) + (2.3×10^3 × V)
24200 = -12100 + 2.3×10^3V
2.3×10^3V = 36300
V = 15.7 m/s

Answer from: Quest

Answer: abeexplanation:

1. the question asks the most appropriate, which seems to rule out "all of the above." your choice appears to be the correct one.

2. the protocol described is good for identifying correlation, but not cause and effect. for cause/effect, you need to devise a protocol that will assign the treatment (or not) to groups that have essentially the same "demographics" with respect to all the other variables. your choice regarding control group seems appropriate. random assignment of treatment (choice d) may be appropriate also. (i think you can argue that b and d are just different descriptions of the same method.)

3. d will randomize the birds, but may not guarantee there are 10 in each group. e will do both, so seems the better choice.

comment on question 2

based on the problem statement, it seems clear that confident, attentive drivers are more likely to use daytime running lights. so, the protocol might need to be devised in such a way that the lights would be turned on or off without the driver's knowledge. (an attentive driver will figure it out.) assigning a confident, attentive driver to a group required to drive without running lights might mess with his/her confidence and attentiveness. you don't want your experiment to do that. (nor do you want the experiment to subject a driver to greater risk of accident as a consequence of driving without running lights.) experiments involving human safety are always problematic.

Answer from: Quest

Wyyeurudydudyeye2y3y3y3ueuudisusuisus7w7uwh2u

Another question on Chemistry

Chemistry, 22.06.2019 01:00

The diagram shows the positions of the sun, moon and earth during spring tides, when the high tides are at their highest and low tides at their lowest. what is it about these positions that causes these high and low tides?

Answers: 3

Answer

Chemistry, 22.06.2019 03:10

The covalent compound acetylene, which is the fuel of the oxyacetylene torch used by welders, has the molecular formula c2h2. the covalent compound benzene, a commercial solvent, has the molecular formula c6h6 each of these covalent compounds contains carbon and hydrogen atoms in a one-to-one ratio. would it be correct to write the chemical formulas of each as ch? explain.

Answers: 1

Answer

Chemistry, 22.06.2019 07:30

Aradio signal from a gps satellite take only about 0.067 seconds to reach a gps reciever. if the speed of light is about 300,000km/s, then approximately how far away is the reciever from from the satellite?

Answers: 1

Answer

Chemistry, 22.06.2019 14:30

What is the relationship between wind and ocean waves? question 17 options: wind moving at higher speeds will transfer more energy to the water, resulting in stronger waves. wind moving at higher speeds will transfer energy over a larger part of the ocean water, resulting in waves with a shorter wavelength. winds moving at higher speeds with cause water to move forward at faster rates, causing larger ocean waves. winds moving at higher speeds will affect deeper water, resulting in waves that move at a faster rate. how do temperature and salinity affect deepwater currents? question 15 options: as temperatures and salinity levels of water increase, the water rises to the surface where it creates currents as it moves to colder regions. they create changes in wind direction, moving denser water in the same direction as the wind and causing the deepwater circulation patterns found in the ocean. they equalize the forces on undersea currents caused by the coriolis effect as they replace more dense water with less dense water. they create density differences that cause dense deepwater currents to flow toward the equator where they displace less dense, warmer water above them.

Answers: 2

Answer

You know the right answer?

Acar with a mass of 1.1 × 103 kilograms hits a stationary truck with a mass of 2.3 × 103 kilograms f...

Questions