subject
Chemistry, 04.06.2021 21:30 nya4657

Investigating Energy Interactions in the Sim Part 1: Investigating Energy Interactions in the Sim

Use the Simulation to investigate this question: tWhat happens when energy interacts with carbon dioxide or methane in the atmosphere? Write your initial claim for the question below.

Initial Claim:

Using the Sim? Follow the Sim Investigation Instructions below.

Sim Investigation Directions:
Set the gas you are investigating to MAXIMUM and the other gases to ZERO.
Press on the eye icon to make the gas you are investigating visible.
Choose an energy arrow that is moving away from Earth. Press on the arrow to activate the tracking function. The other arrows will fade and this arrow's track will be visible.
Press PLAY and observe.
If your energy arrow leaves Earth’s system, choose a new one. Be patient; it may take a few tries before you capture an interaction!
If your energy arrow interacts with a gas, continue observing until that energy arrow leaves the Earth system, then pause. Describe what happened and make a sketch of each interaction.
Try to capture three interactions.

Investigating Energy Interactions in the Sim (continued)
Interaction 1
Describe what you observed.

Make a sketch.

Interaction 2
Describe what you observed.

Make a sketch.
Interaction 3
Describe what you observed.

Make a sketch.

Investigating Energy Interactions in the Sim (continued)
Part 2: Summarizing Results from the Sim Investigation

What happens when energy interacts with carbon dioxide and methane in the atmosphere?

Was your initial claim accurate? Based on your investigation, how would you answer this question now?

ansver
Answers: 3

Another question on Chemistry

question
Chemistry, 22.06.2019 04:00
Two nitro no2 groups are chemically bonded to a patch of surface. they can't move to another location on the surface, but they can rotate (see sketch at right). it turns out that the amount of rotational kinetic energy each no2 group can have is required to be a multiple of ε, where =ε×1.010−24 j. in other words, each no2 group could have ε of rotational kinetic energy, or 2ε, or 3ε, and so forth — but it cannot have just any old amount of rotational kinetic energy. suppose the total rotational kinetic energy in this system is initially known to be 32ε. then, some heat is removed from the system, and the total rotational kinetic energy falls to 18ε. calculate the change in entropy. round your answer to 3 significant digits, and be sure it has the correct unit symbol.
Answers: 2
question
Chemistry, 22.06.2019 10:00
When a septic tank backs up a goes in to clean it out
Answers: 2
question
Chemistry, 22.06.2019 17:10
In which block of the periodic table is uranium (u) found? s blockd blockp blockf block
Answers: 1
question
Chemistry, 22.06.2019 21:30
If you burn 46.6 g of hydrogen and produce 416 g of water, how much oxygen reacted
Answers: 3
You know the right answer?
Investigating Energy Interactions in the Sim Part 1: Investigating Energy Interactions in the Sim
Questions
question
History, 28.10.2020 05:00
question
Mathematics, 28.10.2020 05:00
question
Mathematics, 28.10.2020 05:00
Questions on the website: 13722367