Balance each of the following equations. Then, drag and drop each equation to match the coefficient of H2O in the balanced chemical equation. A coefficient for water may be used once, more than once, or not at all. Drag and drop your selection from the following list to complete the C2H5OH + O2 + CO2 + H2O NH3 + O2 + NO2 + H20 C3H2 + O2 + CO2 + H2O H2SO4 + NaOH → Na2SO4 + H20 NO2 + H2O → HNO3 + NO

C₂H₅OH + 3 O₂ → 2 CO₂ + 3 H₂O

2 NH₃ + 3.5 O₂ → 2 NO₂ + 3 H₂O

C₃H₈ + 5 O₂ → 3 CO₂ + 4 H₂O

H₂SO₄ + 2 NaOH → Na₂SO₄ + 2 H₂O

3 NO₂ + H₂O → 2 HNO₃ + NO

Explanation:

We will balance the equation using the trial and error method.

C₂H₅OH + O₂ → CO₂ + H₂O

1) We balance C atoms by multiplying CO₂ by 2 and H atoms by multiplying H₂O by 3.

C₂H₅OH + O₂ → 2 CO₂ + 3 H₂O

2) We balance O atoms by multiplying O₂ by 3.

C₂H₅OH + 3 O₂ → 2 CO₂ + 3 H₂O

NH₃ + O₂ → NO₂ + H₂O

1) We balance H atoms by multiplying NH₃ by 2 and H₂O by 3.

2 NH₃ + O₂ → NO₂ + 3 H₂O

2) We balance N atoms by multiplying NO₂ by 2.

2 NH₃ + O₂ → 2 NO₂ + 3 H₂O

3) We balance O atoms by multiplying O₂ by 3.5

2 NH₃ + 3.5 O₂ → 2 NO₂ + 3 H₂O

C₃H₈ + O₂ → CO₂ + H₂O

1) We balance C atoms by multiplying CO₂ by 3 and H atoms by multiplying H₂O by 4.

C₃H₈ + O₂ → 3 CO₂ + 4 H₂O

2) We balance O atoms by multiplying O₂ by 5.

C₃H₈ + 5 O₂ → 3 CO₂ + 4 H₂O

H₂SO₄ + NaOH → Na₂SO₄ + H₂O

1) We balance Na atoms by multiplying NaOH by 2.

H₂SO₄ + 2 NaOH → Na₂SO₄ + H₂O

2) We balance H and O atoms by multiplying H₂O by 2.

H₂SO₄ + 2 NaOH → Na₂SO₄ + 2 H₂O

NO₂ + H₂O → HNO₃ + NO

1) We balance H atoms by multiplying HNO₃ by 2.

NO₂ + H₂O → 2 HNO₃ + NO

2) We balance N atoms by multiplying NO₂ by 3.

3 NO₂ + H₂O → 2 HNO₃ + NO

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.