Chemistry, 23.07.2019 12:30 soleil26

Worth 50points. it’s a lab report so i already did the calculations, however, i still need with the introduction, procedures, and discussion (ex. why there are errors for each trial if there are any.) , . done like an essay, . (in your own words)

Answers: 1

Show answers

Answers

Answer from: yoyo1542

Without more information I can’t help you write the actual essay but I can help you with the formatting.

For the introduction, you need background information for you experiment. Why you did it, why you used what you used, basically anything that the reader needs to know before you go into detail about the actual experiment.

The procedures are easy. You essentially just need to walk the reader through the experiment step by step with enough detail that they could recreate it on their own if they wanted. I don’t know about your teacher, but most prefer you don’t use personal pronouns (I.e. “I” “me” “my” “you” etc) so I usually write them as a set of commands (“first, make sure any surfaces being used are throughly sterilized”)

For sources of error, look through the experiment. Are there any areas where contamination could occur? Were there any measurements you had to take that were inexact or could’ve been misread or misinterpreted? Things like that.

Hope this helps! Good luck!

Answer from: arguellesjavier15

Without more information I can’t help you write the actual essay but I can help you with the formatting.

For the introduction, you need background information for you experiment. Why you did it, why you used what you used, basically anything that the reader needs to know before you go into detail about the actual experiment.

The procedures are easy. You essentially just need to walk the reader through the experiment step by step with enough detail that they could recreate it on their own if they wanted. I don’t know about your teacher, but most prefer you don’t use personal pronouns (I.e. “I” “me” “my” “you” etc) so I usually write them as a set of commands (“first, make sure any surfaces being used are throughly sterilized”)

For sources of error, look through the experiment. Are there any areas where contamination could occur? Were there any measurements you had to take that were inexact or could’ve been misread or misinterpreted? Things like that.

Hope this helps! Good luck!

Explanation:

Answer from: Quest

Is there a diagram/picture you can provide? it seems this question goes along with a

Answer from: Quest

120,630,890

step-by-step explanation:

110+10=120,620+10=630,880+10=890

Another question on Chemistry

Chemistry, 22.06.2019 04:00

You encounter a solution that is acidic and you decide to test it by adding a small amount of a strong acid. the ph lowers slightly but is approximately unchanged, and still remains acidic. what can you say about the solution? a. it is a buffer solution. b. it is not a buffer solution it is a strong acid solution. d. the solution has been neutralized. e. the solution has excess acid present

Answers: 1

Answer

Chemistry, 22.06.2019 09:00

If you chip a tooth, most likely you will go to the dentist to have the missing material filled in. currently the material used to fill in teeth is a polymer that is flexible when put in, yet is hardened to the strength of a tooth after irradiation with blue light at a wavelength of 461 nm. what is the energy in joules for a photon of light at this wavelength?

Answers: 1

Answer

Chemistry, 22.06.2019 11:00

What can be found in the ionosphere

Answers: 1

Answer

Chemistry, 22.06.2019 14:30

Which of the following represents the ester functional group? a. -coo- b. -cho c. -cooh d. c=o

Answers: 1

Answer

You know the right answer?

Worth 50points. it’s a lab report so i already did the calculations, however, i still need with the...