Computers and Technology, 17.07.2019 17:00 angelina0miles

Which action is legal for pwc operators traveling at greater than "slow, no wake speed"?

Answers: 1

Show answers

Answers

Answer from: yay47

When operating a PWC at greater than “slow, no wake speed,” you must:

1. Stay at least 200 feet from any Great Lakes shoreline.
2. Not cross within 150 feet behind another vessel other than another PWC.

According to this law, anyone will operate a ship with an engine of maximum sixty horsepower. However, someone below age twelve could operate a ship with someone aboard a minimum of sixteen years getting on if the engine doesn't exceed thirty-five horsepower unit. From ages twelve to fifteen, someone will exceed the lower ordinance with a seafaring safety certificate on board or someone sixteen or older. At 16, someone will operate a ship of any legal speed while not superintendence.

Answer from: jrfranckowiak

When working a PWC at more prominent than "slow , no wake speed," you should Stay at any rate 200 feet from any Great Lakes shoreline and Not cross inside 150 feet behind another vessel other than another PWC.

Further Explanation:

Lawful for PWC administrators:

Law Concerning PWC Operators and Hours of Operation. You should be in any event 14 years old to work a PWC, except if an administering individual at any rate 16 years old is likewise ready the individual watercraft. On the off chance that a PWC is worked around evening time (dusk to dawn), the PWC must show the required route lights.

Required on a PWC:

Each individual on board a PWC must wear a U.S. Coast Guard–affirmed wearable PFD (life jacket).If the PWC is outfitted with a motor cut-off switch, the cord must be joined to the individual, attire, or PFD of the administrator.

Activity is alright for a PWC:

The activity which is alright for a pwc is Seating a kid to little to hang on the administrator before the administrator. This is the correct answer since two travelers behind the administrator is alright for a PWC.

Subject: Computers and technology

Level: High School

Keywords: lawful for PWC administrators, required on a PWC, activity is alright for a PWC.

Another question on Computers and Technology

Computers and Technology, 22.06.2019 07:30

Events and conditions that happen within an organization that are somewhat easier to deal with when responding to change are called

Answers: 1

Answer

Computers and Technology, 23.06.2019 06:30

Who can provide you with a new password when you have forgotten your old one? your provide you with a new password in case you forget your old one.

Answers: 3

Answer

Computers and Technology, 23.06.2019 09:30

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Answers: 1

Answer

Computers and Technology, 23.06.2019 09:30

Write a function called checkfactor that takes two arrays of positive numbers, firstnumberrow and secondnumberrow. checkfactor checks if the first entry in firstnumberrow is divisible by the first entry in secondnumberrow, and performs the same operation on the next array elements until all entries have been checked. all the numbers are positive and the number of entries in the arrays are the same. the function should return the identified divisible numbers in two row arrays named firstdivisible and seconddivisible.restrictions: branches or loops should not be used. the code must use the internal mod and logical functions.hint: the mod function should be used to determine if two numbers are divisible. ex: for num1 and num2 if mod(num1,num2) is 0, then the two numbers are divisible.this is matlab