Designers should take into consideration the user's technical experience when designing an interface. true or false

An endless cycle of creation and response on the internet is called

Report all segments of identity by descent longer than 20 polymorphisms between pairs of individuals in the following cohort of 15 individuals across 49 polymorphisms: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 numeric input 2 points possible (graded) you have 2 attempts to complete the assignment below. for example if the sequence is "bcd", which occurs in "abcdef" , the starting point would be 2 (b), and the finishing point would be 4(d). individuals 7,10 between positions

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."