What are the various types of security attacks to deal with in distributed systems?

The cm is responsible for overseeing the actions of the crisis management team and coordinating all crisis management efforts in cooperation with disaster recovery and/or business continuity planning, on an as-needed basis

Consider a slotted aloha system, where the time slot equals the fixed duration of each packet. assume that there are 4 stations a,b,c,d sharing the medium. (a) stations a,b,c,d receive one packet each from higher layers at times 1.3, 1.5, 2.6,5.7 respectively. show which transmissions take place when, according to the slottedaloha protocol; describe all transmissions until all four packets have been successful.when needed, each station has access to the following sequence of random number, provided by a random number generator and drawn uniformly between 0 and 1: (1) station a draws numbers: 0.31, 0.27, 0.78, 0.9, 0.9, 0.11, 0. (2) station b draws numbers: 0.45, 0.28, 0.11, 0.83, 0.37, 0.22, 0. (3)station c draws numbers: 0.1, 0.2, 0.3, 0.4, 0. (4) station d draws numbers: 0.36, 0.77, 0.9, 0.1, 0.1, 0.1, 0.1, 0. (b) in slotted aloha, a station transmits in each time slot with a given probability. what probabilities would you assign to each of the four stations so as to: (i) maximize the efficiency of the protocol? (ii) maximize fairness among the four stations? (c) will the efficiency increase or decrease if we modify slotted aloha as follows: (i) get rid of slots and allow stations to transmit immediately? (ii) implement carrier sensing? (iii) implement collision detection? (iv) implement collision avoidance?

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it