Where should you put the argument for a command

Write a program that defines symbolic names for several string literals (chars between quotes). * use each symbolic name in a variable definition. * use of symbolic to compose the assembly code instruction set can perform vara = (vara - varb) + (varc - vard); ensure that variable is in unsigned integer data type. * you should also further enhance your symbolic logic block to to perform expression by introducing addition substitution rule. vara = (vara+varb) - (varc+vard). required: debug the disassembly code and note down the address and memory information.

Given a link with a maximum transmission rate of 32.8 mbps. only two computers, x and y, wish to transmit starting at time t = 0 seconds. computer x sends filex (4 mib) and computer y sends filey (244 kib), both starting at time t = 0. statistical multiplexing is used, with details as follows packet payload size = 1000 bytes packet header size = 24 bytes (overhead) ignore processing and queueing delays assume partial packets (packets consisting of less than 1000 bytes of data) are padded so that they are the same size as full packets. assume continuous alternating-packet transmission. computer x gets the transmission medium first. at what time (t = ? ) would filey finish transmitting? give answer in milliseconds, without units, and round to one decimal places (e.g. for an answer of 0.013777 seconds you would enter "13.8" without the quotes)

The volume v and paper surface area a of a conical paper cup are given by where r is the radius of the base of the cone and h is the height of the cone. a. by eliminating h, obtain the expression for a as a function of r and v. b. create a user-de ned function that accepts r as the only argument and computes a for a given value of v. declare v to be global within the function. c. for v ! 10 in.3 , use the function with the fminbnd function to compute the value of r that minimizes the area a. what is the corresponding value of the height h? investigate the sensitivity of the solution by plotting v versus r. how much can r vary about its optimal value before the area increases 10 percent above its minimum value?