Consider a program involving at least one selection structure that could be used in your (intended) field or that could be of use to you as a student. in plain english, describe the program and how it works. if the program is especially complex, you may instead examine a smaller discernible section of the program for this discussion. in light of your plain english description of the program, write a pseudocode for your program if you were to consider implementing the program in matlab. was writing the pseudocode in organizing your thoughts about how the mechanics of such a program would work? do you see a benefit to planning out a program before turning to the language to implement the program?

1. ask the user how many questions are in the quiz. 2. ask the user to enter the key (that is, the correct answers). there should be one answer for each question in the quiz, and each answer should be an integer. e.g., 34 7 13 100 81 3 9 10 321 12 might be the key for a 10-question quiz. you will need to store the key in an array. 3. ask the user to enter the answers for the quiz to be graded. there needs to be one answer for each question. note that these answers do not need to be stored; each answer can simply be compared to the key as it is entered. 4. when the user has entered all of the answers to be graded, print the number correct and the percent correct. 5. add a loop so that the user can grade any number of quizzes with a single key. after the results have been printed for each quiz, ask "grade another quiz? (y/n)." note: you only have one array (the key). you are not creating a new key for each set of quiz answers.