Agood rule of thumb is to design the horizontal stabilizer so that its area is about 1/6 to 1/8 of the area of the wing. if the area of the wing is 106.6 cm2(squared) which of the following would be a good horizontal stabilizer design?
stabilizer with area = 32 cm2
stabilizer with area = 16 cm2 stabilizer with area = 40 cm2
stabilizer with area = 12 cm2
i need with this-

In a heat transfer course, we can derive the equation for the temperature distribution in a flat rectangular plate. in this example, we will look at a plate at steadystate with three sides being held at t1, and one side held at t2. the temperature for any location on the plate, t(x,y), can be calculated by where create a function (prob3_5) that will take inputs of vectors x and y in feet, scalar n, scalars l and w in feet and scalars t1 and t2 in degrees fahrenheit. it will output a matrix t which is the temperature of each x and y locations. t will have the number of columns equal to the number of elements in x and rows equal to the number of elements in y. though this can be done without loops (perhaps more efficiently), your program must use a nested loop.