Assume there are two variables, k and m, each already associated with a positive integer value and further assume that k's value is smaller than m's. write the code necessary to compute the number of perfect squares between k and m. (a perfect square is an integer like 9, 16, 25, 36 that is equal to the square of another integer (in this case 3*3, 4*4, 5*5, 6*6 associate the number you compute with the variable q. for example, if k and m had the values 10 and 40 respectively, you would assign 3 to q because between 10 and 40 there are these perfect squares: 16, 25, and 36.

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Which best describes the role or restriction enzymes in the analysis of edna a. to break dna into fragments that vary in size so they can be sorted and analyzed b. to amplify small amounts of dna and generate large amounts of dna for analysis c. to purify samples of dna obtained from the environment so they can be analyzed d. to sort different sizes of dna fragments into a banding pattern that can be analyzed

Use a physical stopwatch to record the length of time it takes to run the program. calculate the difference obtained by calls to the method system.currenttimemillis() just before the start of the algorithm and just after the end of the algorithm. calculate the difference obtained by calls to the method system.currenttimemillis() at the start of the program and at the end of the program so that the elapsed time includes the display of the result. use the value returned by the method system.currenttimemillis() just after the end of the algorithm as the elapsed time.