Computers and Technology, 20.04.2020 05:03 lpssprinklezlps

Example 2: The table below shows the thermostat setting (in units called gas marks) on a British gas oven and the
corresponding temperature in degrees Celsius.
2
2
3
4
8
Setting
(gas mark)
Temperature
(°C)
150
160
180
190
200
220
230
1. Create a scatter plot on the right, Is there positive or
negative correlation?
2. Write the equation of a line of best fit. Show all work.
Temperature (C)
3. Graph your equation against the scatter plot. There should
be approximately as many points above the line as below.
0
1
8 x
4. Predict the temperature when the thermostat is set at 12.
Show your set-up. You may use a calculator for calculations,
2 3 4 5 6 7
Setting (gas mark)

Answers: 1

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 16:30

Corey set up his presentation for delivery to his team.the information he had to convey was critical to their job performance.he knew he would need a lot of time to explain each point

Answers: 3

Answer

Computers and Technology, 22.06.2019 21:50

Answer the following questions regarding your system by using the commands listed in this chapter. for each question, write the command you used to obtain the answer. a. what are the total number of inodes in the root filesystem? how many are currently utilized? how many are available for use? b. what filesystems are currently mounted on your system? c. what filesystems are available to be mounted on your system? d. what filesystems will be automatically mounted at boot time?

Answers: 1

Answer

Computers and Technology, 23.06.2019 16:00

What is the biggest difference between section breaks and regular page breaks? section breaks are more difficult to add than page breaks. section breaks make it easier for you to view the document as an outline. section breaks allow you to have areas of the document with different formatting. section breaks are smaller than regular page breaks.

Answers: 2

Answer

Computers and Technology, 24.06.2019 10:00

Each time you save a document, you will need to type in the file type in which it should be saved you can select the save button to save it with the same file name if it has been previously saved you will need to select the location to save the file you will need to use the save as dialog box

Answers: 1

Answer

You know the right answer?

Example 2: The table below shows the thermostat setting (in units called gas marks) on a British gas...

Questions