2. ARQ Protocols: Stop and Wait/Go Back N/Selective Repeat a. Why are we studying these protocols: Stop and Wait, Go Back N and Selective Repeat? b. Why do the protocols need sequence numbers (SN) to operate? c. Why do we need ACKs? d. Why do the protocols require a Timer? e. What are 3 different events that can cause the timer to expire in the ARQ protocols?

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

The camera still is bad even with the new iphone xr and especially in low light it is even worst because you can see the pixels more if its in low light. if all you apple customers want apple to fix this then lets fill there feedback with complaints about the

An environmental protection agency study of 12 automobiles revealed a correlation of 0.47 between engine size and emissions. at 0.01 significance level, can we conclude that there is a positive association between the variables? what is the p value? interpret.