Is 4th gen. computers portabe ?

Write a function so that the main program below can be replaced by the simpler code that calls function original main program: miles_per_hour = float( minutes_traveled = float( hours_traveled = minutes_traveled / 60.0 miles_traveled = hours_traveled * miles_per_hour print('miles: %f' % miles_traveled) sample output with inputs: 70.0 100.0 miles: 116.666667

You need to design a circuit that implements the functions in the following table: s0 s1 function0 0 a + 10 1 a – b1 0 a + b1 1 a – 1s0 and s1 are 1-bit control inputs to select the function of the circuit. inputs a and b are 4-bitnumbers in 2s complement form. the output is also a 4-bit number in 2s complement form.you are allowed to use only one ttl 7483 4-bit adder to implement all the functions. but anynumber of other components (except the adder) can be used.hint: design a combinational logic circuit to modify the input b and the “carry input” of theadder depending on the control inputs s0 and s1.important: lab grade will depend on the working of the circuit & will be checked of by your labinstructor.1. is the output valid for the following input combinations: a. s0 = 0, s1 = 0, a = 7, b = 3? b. s0 = 0, s1 = 1, a = 7, b = 3? c. s0 = 1, s1 = 0, a = -4, b = -5? d. s0 = 1, s1 = 1, a = -8, b = 6? 2. what is the range of inputs (for both a and b) that will produce the valid output for all the functions?

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.