Computers and Technology, 01.07.2020 19:01 fmyear12

Design an Ethernet network to connect as a single client PC to a single server. Both the client and the server will connect to their workgroup switches via UTP. The two devices are 900 meters apart. They need to communicate at 800 Mbps. Your design will specify the locations of any switches and the transmission link between the switches.

Answers: 1

Show answers

Answers

Answer from: stuckonquestions

We would need 3 switches to connect a single client PC to a single server.

Connect server to switch 1 (225 m)Connect switch 1 to switch 2 (225 m)Connect switch 2 to switch 3 (225 m)Connect switch 3 to client PC (225 m)

Explanation:

The maximum distance for ethernet connection is approximately 100 meters for transmission speeds up to 1000 Mbps but the distance may be increased if we add network switches between the client PC and the server.

After the addition of network switches, the distance may be increased up to 200 meters plus 10 to 30 meters more without any substantial decrease in transmission speed.

So we have 900 meters of distance between the client PC and the server.

The Ethernet network may be designed as below:

Connect server to switch 1 (225 m)Connect switch 1 to switch 2 (225 m)Connect switch 2 to switch 3 (225 m)Connect switch 3 to client PC (225 m)

Total distance covered = 225 + 225 + 225 + 225

Total distance covered = 900 meters

Therefore, we would need 3 switches to connect a single client PC to a single server.

The layout of the design is illustrated in the attached diagram.

Design an Ethernet network to connect as a single client PC to a single server. Both the client and

Answer from: Quest

the benefits of raising bc’s minimum wage to $15 through a

series of pre-announced staged increases far outweigh the likely

costs. claims that such an increase will lead to massive job losses

in low-wage sectors of the economy are not credible.

• an increase to $15 would result in some job losses. however,

the likely impact is less than a 1 per cent reduction in the overall

provincial employment rate, and a 7.6 per cent reduction in the

employment rate for those currently making between $10.25

and $15 per hour.

• the large job loss impacts predicted by some opponents of

minimum wages misrepresent the existing economic research. in

reading and using that research, it is important to recognize that

estimates showing job loss effects of minimum wage increases

apply only to teenagers. estimated effects for young adult and

adult workers range from insignificant to non-existent.

• focusing on teenage workers plays up an inaccurate stereotype

about who earns very low wages in bc and leads to exaggerated

claims about job losses. only 26 per cent of those currently making

between $10.25 and $12 are teenagers, and only 5 per cent

of those making between $12 and $15 are teenagers.

Answer from: Quest

The correct answer to go in the blank would be a) complement.

Another question on Computers and Technology

Computers and Technology, 22.06.2019 05:20

Write a program called assignment3 (saved in a ﬁle assignment3.java) that computes the greatest common divisor of two given integers. one of the oldest numerical algorithms was described by the greek mathematician, euclid, in 300 b.c. it is a simple but very e↵ective algorithm that computes the greatest common divisor of two given integers. for instance, given integers 24 and 18, the greatest common divisor is 6, because 6 is the largest integer that divides evenly into both 24 and 18. we will denote the greatest common divisor of x and y as gcd(x, y). the algorithm is based on the clever idea that the gcd(x, y) = gcd(x ! y, y) if x > = y and gcd(x, y) = gcd(x, y ! x) if x < y. the algorithm consists of a series of steps (loop iterations) where the “larger” integer is replaced by the di↵erence of the larger and smaller integer. this continues until the two values are equal. that is then the gcd.

Answers: 3

Answer

Computers and Technology, 22.06.2019 10:30

Think about a recent customer service experience - either positive or negative. write a brief summary of that experience. now think about those four characteristics we look for in customer service representatives. how did the representative in your example stack up? write down your answer and give specific examples.

Answers: 1

Answer

Computers and Technology, 22.06.2019 13:00

Which part of the cpu accepts data?

Answers: 1

Answer

Computers and Technology, 23.06.2019 06:30

You have a small company and want to keep your costs low, but it is important your employees share data. which network would provide you with the most economical solution?

Answers: 1

Answer

You know the right answer?

Design an Ethernet network to connect as a single client PC to a single server. Both the client and...

Questions