Computers and Technology, 20.09.2020 03:01 mbprez6029

What additional uses of technology can you see in the workplace?

Answers: 2

Show answers

Answers

Answer from: Quest

answer; the above statement is (false); a computer (word) is the amount of data;

Answer from: Quest

Hypothesis: volumes of both figures are equal.the volume of figure 1 is: $v_1=a_{basis}\cdot h=\frac{1}{2} \cdot 5\cdot7\sin \alpha\cdot 8=280\sin \alpha$ .the volume of figure 2 is: $v_2=a\cdotb\cdotc=5\cdot7\cdot8=280$ .since $0\le \alpha\le \pi$ , you can conclude that $0\le\sin\alpha\le1$ and $0\le v_1\le 140$ . so, $v_1\le v_2$ .volumes of figures are equal only when an angle in the basis is right (then figures will be the same), in another cases volume of figure 1 is less than volume of figure 2.the hypothesis was not correct in all cases.

Answer from: Quest

The answer is c. 36======analyzing the for-loop, we see that the control variable, k, starts at 0 and increments by after every loop iteration. the condition $\texttt{k\ \textless \ =7}$ tells us that the loop will stop when k is above 7; in this case, when k is 8.0 1 2 3 4 5 6 7 are the values for k that will be used. each number is for each iteration; therefore, the for-loop will have 8 iterations in total.the code inside the loop itself goes like this: 1st iteration (k=0)starting with sum=0, val=1 $\texttt{sum += val; }$ means that add $\texttt{val}$ to $\texttt{sum}$ .since sum is 0 and val is 1, 0 + 1 = 1. the new value of sum is 1. $\texttt{val++; }$ means to increment $\texttt{val}$ by 1.since val is 1, the new value of val of 2.end of iteration with k=0; k is increased by one to become k=12nd iteration (k=1)starting with sum=1, val=2 $\texttt{sum += val; } \iff \texttt{sum = 1 + 2}$ ======let us establish a pattern. this is moreso logic than programming: we can rewrite $\texttt{sum = 1 + 2}$ so that we have the elements from the previous iteration. the 1 came from 0 + 1 before. so we can write it as $\texttt{sum = 0 + 1 + 2}$ .and if we did the third iteration, by the end, sum would look like $\texttt{sum = 0 + 1 + 2 + 3}$ notice how the number of plus signs is equal to the iteration you are on (which is just k+1), and what is being added is increasing by one each time. for example, the third iteration (k=2) ends up with $\texttt{sum = 0 + 1 + 2 + 3}$ with 3 plus signs.the second iteration (k=1) ends up with $\texttt{sum = 0 + 1 + 2}$ with two plus signs.the first iteration (k=0) ends up with $\texttt{sum = 0 + 1}$ with one plus sign.this is a pattern. the nth iteration will have n plus signs.since we established before that there are 8 iterations of this loop in total, the value of sum at k=7 (the 8th and last iteration) will have sum with 8 plus signs. $\begin{aligned} \texttt{sum} & = \texttt{0 + 1 + 2 + 3 + 4 + 5 + 6 + 7 + 8 } \\ & = \texttt{3 + 3 + 4 + 5 + 6 + 7 + 8 } \\ & = \texttt{6 + 4 + 5 + 6 + 7 + 8 } \\ & = \texttt{10 + 5 + 6 + 7 + 8 } \\ & = \texttt{15 + 6 + 7 + 8 } \\ & = \texttt{21 + 7 + 8 } \\ & = \texttt{28 + 8 } \\ & = \texttt{36} \end{aligned}$ so the value of sum at the end of the loop is 36.

Answer from: Quest

The answer is "line style".

Another question on Computers and Technology

Computers and Technology, 22.06.2019 02:20

The reset circuit used on the four 3-bit counters analyzed in this activity reset the counts to zero (000). it makes sense for the up-counters to start at zero (000), but the down-counters should start at seven (111). what would you need to change so that the 3-bit binary down counter with j/k flip-flops you just created would reset to seven (111)?

Answers: 1

Answer

Computers and Technology, 22.06.2019 09:50

17. implement the jvm dload instruction for the mic-2. it has a 1-byte index and pushes the local variable at this position onto the stack. then it pushes the next higher word onto the stack as well

Answers: 2

Answer

Computers and Technology, 24.06.2019 18:00

Which of the following is an example of synchronous communication? a) e-mail b) voicemail c) telephone conversation d) text message.

Answers: 1

Answer

Computers and Technology, 24.06.2019 22:30

In writing a paper for his english class, gavin quoted an author of the book. what should he include in his paper to credit the source? citation caption header entry