Computers and Technology, 16.10.2020 23:01 brevinsparks4

Inswer any three questions. TIOX3-300
1. What is computer system? Explain the components of compute

system with block diagram.
(283

Answers: 2

Show answers

Another question on Computers and Technology

Computers and Technology, 21.06.2019 22:00

Determine which of the four levels of measurement (nominal, ordinal, interval, ratio) is most appropriate for the data below. internet speed levels of "fast comma " "medium comma " and "slow" choose the correct answer below. a. the ordinal level of measurement is most appropriate because the data can be ordered comma but differences left parenthesis obtained by subtraction right parenthesis cannot be found or are meaningless. nothing nothing nothing nothing nothing b. the interval level of measurement is most appropriate because the data can be ordered comma differences left parenthesis obtained by subtraction right parenthesis can be found and are meaningful comma and there is no natural starting point. c. the nominal level of measurement is most appropriate because the data cannot be ordered. nothing d. the ratio level of measurement is most appropriate because the data can be ordered comma differences left parenthesis obtained by subtraction right parenthesis can be found and are meaningful comma and there is a natural starting point.

Answers: 2

Answer

Computers and Technology, 22.06.2019 20:40

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it

Answers: 2

Answer

Computers and Technology, 23.06.2019 01:00

Let r be a robotic arm with a fixed base and seven links. the last joint of r is a prismatic joint, the other ones are revolute joints. give a set of parameters that determines a placement of r. what is the dimension of the configuration space resulting from your choice of parameters?

Answers: 3

Answer

Computers and Technology, 24.06.2019 20:30

Drums installed, you would apply clicks of the parking brake to obtain a slight drag on both rear wheels

Answers: 1

Answer

You know the right answer?

Inswer any three questions. TIOX3-300
1. What is computer system? Explain the components of co...

Questions