What's the least number of bits that you'll need to represent the current minute (0-59) in binary?

Draw the hierarchy chart and design the logic for a program that calculates service charges for hazel's housecleaning service. the program contains housekeeping, detail loop, and end-of-job modules. the main program declares any needed global variables and constants and calls the other modules. the housekeeping module displays a prompt for and accepts a customer's last name. while the user does not enter for the name, the detail loop accepts the number of bathrooms and the number of other rooms to be cleaned. the service charge is computed as $40 plus $15 for each bathroom and $10 for each of the other rooms. the detail loop also displays the service charge and then prompts the user for the next customer's name. the end-of-job module, which executes after the user enters the sentinel value for the name, displays a message that indicates the program is complete.

Consider this data sequence: "3 11 5 5 5 2 4 6 6 7 3 -8". any value that is the same as the immediately preceding value is considered a consecutive duplicate. in this example, there are three such consecutive duplicates: the 2nd and 3rd 5s and the second 6. note that the last 3 is not a consecutive duplicate because it was preceded by a 7. write some code that uses a loop to read such a sequence of non-negative integers , terminated by a negative number. when the code finishes executing, the number of consecutive duplicates encountered is printed. in this case, 3 would be printed. assume the availability of a variable, stdin, that references a scanner object associated with standard input. that is, stdin = new scanner(system.in); is given.

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.