Computers and Technology, 25.11.2020 14:00 LuvIsRage2

Why does a bus topology require a terminator? a) because otherwise it would be a ring network b) because otherwise the packets will bounce back and forth from end to end repeatedly c) because otherwise the signal will fade out d) because a terminator is where a bus network connects to the outside

Answers: 3

Show answers

Answers

Answer from: djdjdjdbdbjx

B)because otherwise the packets will bounce back and forth from end to end repeatedly

Explanation:

Bus topology can be regarded as a kind of topology for a Local Area Network, it is one that has it's nodes connected to a single cable(backbone) and any break in the so called backbone, there will be failure in the entire segment. However a Terminator is usually attached to the end-points of a bus network so that the signal is absorbed by the Terminator and as a result of this the signal will not reflect back down the line. If there is no Terminator there would be bouncing back and forth of packet in an endless loop.It should be noted that a bus topology require a terminator because otherwise the packets will bounce back and forth from end to end repeatedly

Answer from: SDFGHJKdd

The answer is-

B.) because otherwise the packets will bounce back and forth from end to end repeatedly

Answer from: Quest

For creating a quick presentation with predesigned and preinstalled elements, you should use a presentation template.

Answer from: Quest

Ithink it would be c (a word object) not 100% sure though

Another question on Computers and Technology

Computers and Technology, 22.06.2019 20:40

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it

Answers: 2

Answer

Computers and Technology, 23.06.2019 05:00

In cell b18, enter a formula to calculate the amount budgeted for meals. this amount is based on the daily meal allowance and the total travel days (# of nights+1).

Answers: 1

Answer

Computers and Technology, 23.06.2019 20:00

How much current flows through the alternator brushes? a. 2–5 a b. 25–35 a, depending on the vehicle c. 5–10 a d. 10–15 a

Answers: 2

Answer

Computers and Technology, 24.06.2019 01:30

Hazel has just finished adding pictures to her holiday newsletter. she decides to crop an image. what is cropping an image?

Answers: 1

Answer

You know the right answer?

Why does a bus topology require a terminator? a) because otherwise it would be a ring network b) bec...