Computers and Technology, 19.02.2021 22:10 avahrhey24

Which commands can be found along with the Show Group of the View Tab? commands that let you save the document
commands that change the width of a document
commands that create new windows
commands that toggle the visibility of certain tools

Answers: 3

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 10:20

Print "usernum1 is negative." if usernum1 is less than 0. end with newline. convert usernum2 to 0 if usernum2 is greater than 10. otherwise, print "usernum2 is less than or equal to 10.". end with newline

Answers: 3

Answer

Computers and Technology, 22.06.2019 10:30

How can a user open a blank presentation? 1.on the file menu, click new, and then click recent templates 2.on the file menu, click new, and then click blank presentation 3. on the view menu, click templates, and then click recent templates 4. on the view menu, click samples, and then click blank presentation

Answers: 1

Answer

Computers and Technology, 22.06.2019 14:30

The “rule of 72” is used to approximate the time required for prices to double due to inflation. if the inflation rate is r%, then the rule of 72 estimates that prices will double in 72/r years. for instance, at an inflation rate of 6%, prices double in about 72/6 or 12 years. write a program to test the accuracy of this rule. for each interest rate from 1% to 20%, the program should display the rounded value of 72/r and the actual number of years required for prices to double at an r% inflation rate. (assume prices increase at the end of each year.)

Answers: 1

Answer

Computers and Technology, 22.06.2019 20:40

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it

Answers: 2

Answer

You know the right answer?

Which commands can be found along with the Show Group of the View Tab? commands that let you save t...

Questions