An organization is conducting a study to see if hazardous waste sites pose health risks for cancer or other conditions, such as birth defects or nerve or liver damage.
Which of the following
specialized information systems would give the organization the information it is looking for?

Superfund Information systems

Geographic Information systems

Emergency department Information systems

Electronic medical record systems

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Write pseudocode to represent the logic of a program that allows the user to enter a value. the program multiplies the value by 10 and outputs the result.

Draw the resistor’s voltage and current phasors at t=15ms. draw the vectors with their tails at the origin. the orientation of your vectors will be graded. the exact length of your vectors will not be graded.