Which of the following lines of code would print the docstring for the range() function?
a. print(docstring_range)
b. print(range._doc_)
c. print(range.""doc"")
d. print("range. doc")

Data for which there is temporarily no room in ram is diverted to where on your computer? question 9 options: a) the paging file on the hard drive b) the system file on the hard drive c) the memory file on the hard drive d) the cpu cache

Write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removedproblems 1.1 write a computer program to calculate the three-phase fault current for a fault at f in figure 1.16, with the network normal, and with one line at a time removed 20 power system relaying from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0+j0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the stub-end fault í• figure 1.16 problem 1.1 system data for figure 1.16 from to positive sequence 0.0+j0.1 0.05j0.15 0.04 j0.2 0.01 jo.i 0.015 + j0.15 0.01 j0.19 0.01 +j0.19 0.03+j0.1 0.0+j0.08 6 6 6 from service. the positive-sequence impedance data are given in the accompanying table. use the commonly made assumption that all prefault resistance values are (1.0 + j 0.0) pu, and neglect all resistance values. calculate the contribution to the fault flowing through the cb b1, and the voltage at that bus. for each calculated case, consider the two possibilities: cb b2 closed or open. the latter is known as the “stub-end” fault.

Pthreads programming: create and terminate a thread write a c++ program that creates a thread. the main will display a message “hello world from the main”. the main will create a thread that will display a message “hello world from the thread” and then terminates with a call to pthread_exit()