Computers and Technology, 28.01.2020 20:05 7obadiah

Which of the following roles is responsible for writing programming code?

computer support specialist

software engineer

systems analyst

program manager

Answers: 1

Show answers

Another question on Computers and Technology

Computers and Technology, 23.06.2019 02:30

Three out of five seniors remain undecided about a college major at the end of their senior year.

Answers: 3

Answer

Computers and Technology, 23.06.2019 09:30

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Answers: 1

Answer

Computers and Technology, 23.06.2019 19:30

Anul 2017 tocmai s-a încheiat, suntem trişti deoarece era număr prim, însă avem şi o veste bună, anul 2018 este produs de două numere prime, 2 şi 1009. dorel, un adevărat colecţionar de numere prime, şi-a pus întrebarea: “câte numere dintr-un interval [a,b] se pot scrie ca produs de două numere prime? “.

Answers: 1

Answer

Computers and Technology, 23.06.2019 19:40

Use a physical stopwatch to record the length of time it takes to run the program. calculate the difference obtained by calls to the method system.currenttimemillis() just before the start of the algorithm and just after the end of the algorithm. calculate the difference obtained by calls to the method system.currenttimemillis() at the start of the program and at the end of the program so that the elapsed time includes the display of the result. use the value returned by the method system.currenttimemillis() just after the end of the algorithm as the elapsed time.

Answers: 3

Answer

You know the right answer?

Which of the following roles is responsible for writing programming code?

computer supp...

Questions