Step 2: Program Now, we’re ready to program! Leave the visualizer and go back to https://repl. it/ to write your program.

Here is the pseudocode for your program:

Define a function called “even_checker” that will do the following things:

Iterate over a list.
Check to see whether the values in the list are even.
Print the even values.
Create a list with ten numbers in it. (Some of your numbers should be odd, and some should be even.)

Call the function on your list.

When you have tested your program, take a screenshot of it and its output to turn in. If your program does not work properly, also include a paragraph explaining what you did to troubleshoot it.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."