The following question will try to test your understanding of postix operations, floating point stack and floating point commands. Show what values are in the STO), ST(1), ST(2), and ST(3) registers after all the command are run. If the position in the stack has no value assigned to it leave it blank. data
sngOne REAL4 10.0
sngTwo REAL4 8.5
sngThree REAL4 -13.0

.code
fld sngOne
fld sngTwo
fsub
fld sngThree
fadd

Afiling system in which an intermediary source of reference, such as a file card, must be consulted to locate specific files is called a(n) system. a. shelf filing b. direct filing c. indirect filing d. shingling

Write a program that keeps asking the user for new values to be added to a list until the user enters 'exit' ('exit' should not be added to the list). these values entered by the user are added to a list we call 'initial_list'. then write a function that takes this initial_list as input and returns another list with 3 copies of every value in the initial_list. finally, inside print out all of the values in the new list. for example: input: enter value to be added to list: a enter value to be added to list: b enter value to be added to list: c enter value to be added to list: exit output: a b c a b c a b c note how 'exit' is not added to the list. also, your program needs to be able to handle any variation of 'exit' such as 'exit', 'exit' etc. and treat them all as 'exit'.

You will subnet the network address 172.31.103.0/24. the network has the following requirements: · room-114 lan will require 27 host ip addresses · room-279 lan will require 25 host ip addresses · room-312 lan will require 14 host ip addresses · room-407 lan will require 8 host ip addresses how many subnets are needed in the network topology?