Set up a circuit with 3 LEDs and a button. Make sure to use the 330 Ohm resistors and a 10k Ohm resistor if using one on the button. Connect them to any digital pins of the Arduino. Write a code (starting with a blank Arduino sketch) that includes the following. An if statement:
When pressed the same light pattern that was used in Homework 1 Task 1 happens.
When not pressed one LED blinks at a rate of 1 second while all other LEDs are off

Your program will make use of long long int variables for all calculations. note: the use of long long int requires that you have c++11 support. you should have this automatically if you are using a newer version of visual studio. the support is there for gcc as well, but you may need the -std=c++11 or -std=c++0x compiler flag. you first need to read in the total number of seconds. there is no prompt for the read (that is, you just do the cin without using a cout to display a prompt). this is going to seem a little strange when you are running your program in your ide

Once the data center routes to the destination server that hosts the website, what's the next step in the internet process? user’s browser renders html code from destination server into web page request goes through router/model and isp request routed to nameserver and datacenter

Write a program that defines symbolic names for several string literals (chars between quotes). * use each symbolic name in a variable definition. * use of symbolic to compose the assembly code instruction set can perform vara = (vara - varb) + (varc - vard); ensure that variable is in unsigned integer data type. * you should also further enhance your symbolic logic block to to perform expression by introducing addition substitution rule. vara = (vara+varb) - (varc+vard). required: debug the disassembly code and note down the address and memory information.