Tables should be used when (a) the reader need not refer to specific numerical values. (b) the reader need not make precise comparisons between different values and not just relative comparisons. (c) the values being displayed have different units or very different magnitudes. (d) the reader need not differentiate the columns and rows.

Under which key category do the page up and page down keys fall? page up and page down keys fall under the keys category.

After you clean an engine with hot water spray, it seems to stall; when it doesn't stall, it's idling noisily. technician a says to check for loose bolts on the flex plate near the torque converter. technician b says to wipe down the spark plug wires and the distributor cap. who is correct? a. technician a b. both technicians a and b c. technician b

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."