The load, execute, wait and signal are names of the system calls for process control. device management. file management. information maintenance.

Your program will make use of long long int variables for all calculations. note: the use of long long int requires that you have c++11 support. you should have this automatically if you are using a newer version of visual studio. the support is there for gcc as well, but you may need the -std=c++11 or -std=c++0x compiler flag. you first need to read in the total number of seconds. there is no prompt for the read (that is, you just do the cin without using a cout to display a prompt). this is going to seem a little strange when you are running your program in your ide

Show that there is a language a ⚆ {0, 1} â— with the following properties: 1. for all x â a, |x| ≤ 5. 2. no dfa with fewer than 9 states recognizes a. hint: you don’t have to define a explicitly; just show that it has to exist. count the number of languages satisfying (1) and the number of dfas satisfying (2), and argue that there aren’t enough dfas to recognize all those languages. to count the number of languages satisfying (1), think about writing down all the strings of length at most 5, and then to define such a language, you have to make a binary decision for each string about whether to include it in the language or not. how many ways are there to make these choices? to count the number of dfas satisfying (2), consider that a dfa behaves identically even if you rename all the states, so you can assume without loss of generality that any dfa with k states has the state set {q1, q2, . . , qk}. now think about how to count how many ways there are to choose the other four parts of the dfa.

Write a program that displays the following menu: geometry calculator 1. calculate the area of a circle 2. calculate the area of a rectangle 3. calculate the area of a triangle 4. quit enter your choice (1-4): if the user enters 1, the program should ask for the radius of the circle and then display its area. use the following formula: area = ď€(the square of r) use 3.14159 for ď€ and the radius of the circle for r. if the user enters 2, the program should ask for the length and width of the rectangle and then display the rectangle’s area. use the following formula: area = length * width if the user enters 3, the program should ask for the length of the triangle’s base and its height, and then display its area. use the following formula: area = base * height * .5 if the user enters 4, the program should end. input validation: display an error message if the user enters a number outside the range of 1 through 4 when selecting an item from the menu. do not accept negative values for the circle’s radius, the rectangle’s length or width, or the triangle’s base or height. note: if the user enters an improper menu choice (1-4), the program prints "the valid choices are 1 through 4. run the program again and select one of those." if the user enters a negative radius, the program prints "the radius can not be less than zero." if the user enters a negative value for height or base, the program prints "only enter positive values for base and height."