After reading the case presented in the module, write a short response to the following discussion questions and ethical decision making scenario. Discussion Questions What questions do you think Kelvin should have included on his slide to start the discussion? If the questions were broken down into two categories, they would be cost versus maintaining high security while keeping flexibility. Which is more important for SLS?

3. (5 points) describe what would be printed by the code below or what error would occur. const char* cstr = "0123456"; const char* ptr = & cstr[4]; cout < < ptr[-1] < < ptr < < endl; 1 4. (5 points) theseus has been trapped in a maze with a minotaur, which is trying to capture him. each round, theseus and the minotaur move through the maze; theseus towards the exit, and the minotaur towards theseus. theseus can move in any of the four cardinal directions, or he can wait for a round to see how the minotaur moves. write code that creates a data type to represent the possible moves that theseus could make.

Assume that there is a 4% rate of disk drive failure in a year. a. if all your computer data is stored on a hard disk drive with a copy stored on a second hard disk drive, what is the probability that during a year, you can avoid catastrophe with at least one working drive? b. if copies of all your computer data are stored on three independent hard disk drives, what is the probability that during a year, you can avoid catastrophe with at least one working drive?

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.