Cannot find module or its corresponding type declarations

Alook-up table used to convert pixel values to output values on a monitor. essentially, all pixels with a value of 190 or above are shown as white (i.e. 255), and all values with a value of 63 or less are shown as black (i.e. 0). in between the pixels are scaled so that a pixel with a value p is converted to a pixel of value 2/127 −+3969). if a pixel has a value of 170 originally, what value will be used to display the pixel on the monitor? if a value of 110 is used to display the pixel on the monitor, what was the original value of the pixel?

:you areto design the controller for alight that functions both as an ordinary light and also as a motion activated light and alarm. a.if the manual switch s is on, then the light l is on. b.besides the manual switch, there is a motion detector, m1, which activatesthis light.c.if motion is detected but the light is on anyway because s is on, only then a secondoutput a, an alarm, is turned on. d.the disable switch, d, disables the motion activated light and alarmbut leaves manual control operation of the light using switch s.(i)read the problem statement and clearly identify the inputs and outputs for the circuit you are designing. (ii)create the truth table for this system; include the light, alarm, switch, disable, and the motion sensor.(iii)draw a schematic of this system.

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately