Five functions in MS Excel

Robots with telescoping arms are sometimes used to perform tasks (e.g., welding or placing screws) where access may be difficult for other robotic types. during a test run, a robot arm is programmed to extend according to the relationship r = 3 + 0.5cos(4θ) and the arm rotates according to the relationship θ=−π4t2+πt , where r is in feet, θ is in radians, and t is in seconds. use a computer program to plot the path of tip a in x and y coordinates for 0 ≤ t ≤ 4s.

Write a program that begins by reading in a series of positive integers on a single line of input and then computes and prints the product of those integers. integers are accepted and multiplied until the user enters an integer less than 1. this final number is not part of the product. then, the program prints the product. if the first entered number is negative or 0, the program must print “bad input.” and terminate immediately. next, the program determines and prints the prime factorization of the product, listing the factors in increasing order. if a prime number is not a factor of the product, then it

You need to design a circuit that implements the functions in the following table: s0 s1 function0 0 a + 10 1 a – b1 0 a + b1 1 a – 1s0 and s1 are 1-bit control inputs to select the function of the circuit. inputs a and b are 4-bitnumbers in 2s complement form. the output is also a 4-bit number in 2s complement form.you are allowed to use only one ttl 7483 4-bit adder to implement all the functions. but anynumber of other components (except the adder) can be used.hint: design a combinational logic circuit to modify the input b and the “carry input” of theadder depending on the control inputs s0 and s1.important: lab grade will depend on the working of the circuit & will be checked of by your labinstructor.1. is the output valid for the following input combinations: a. s0 = 0, s1 = 0, a = 7, b = 3? b. s0 = 0, s1 = 1, a = 7, b = 3? c. s0 = 1, s1 = 0, a = -4, b = -5? d. s0 = 1, s1 = 1, a = -8, b = 6? 2. what is the range of inputs (for both a and b) that will produce the valid output for all the functions?