subject
Engineering, 06.07.2019 06:10 jaileen84

Aspeed reducer has 20 full-depth teeth and consists of a 20-tooth steel spur pinion driving a 50-tooth cast-iron gear. the horsepower transmitted is 12 at a pinion speed of 1200 rev/min for a diametral pitch of 8 teeth/in and a face width of 1.5 in, find the contact stress

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
Aspeed reducer has 20 full-depth teeth and consists of a 20-tooth steel spur pinion driving a 50-too...
Questions
question
Mathematics, 05.02.2020 03:54
Questions on the website: 13722367