subject
Engineering, 28.01.2020 11:31 mandi795

In areas where the air temperature remains below o°c for prolonged periods of time, the freezing of water in underground pipes is a major concern. fortunately, the soil remains relatively warm during those periods, and it takes weeks for the subfreezing temperatures to reach the water mains in the ground. thus, the soil effectively serves as an insulation to protect the water from subfreezing temperatures in winter. the ground at a cold location is covered with snow pack at -10°c for a continuous period of two months, and the average soil properties at that location are k 0.4 w/m-k and a 0.15 x10m/s. each pipe of the system is 30 m long with a diameter of 10 cm. assuming an initial uniform temperature of 10°c for the ground and pipe surface, determine: a) the minimum burial depth to prevent the water pipes from freezing, and b) the conduction shape factor and steady rate of heat transfer at the minimum burial depth.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
question
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
question
Engineering, 04.07.2019 18:10
Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k
Answers: 2
You know the right answer?
In areas where the air temperature remains below o°c for prolonged periods of time, the freezing of...
Questions
question
Mathematics, 05.02.2021 02:50
question
Mathematics, 05.02.2021 02:50
question
Mathematics, 05.02.2021 02:50
question
Mathematics, 05.02.2021 02:50
question
Mathematics, 05.02.2021 02:50
question
Mathematics, 05.02.2021 02:50
question
Advanced Placement (AP), 05.02.2021 02:50
question
History, 05.02.2021 02:50
Questions on the website: 13722361