Engineering, 11.07.2019 02:20 akemble8862

An array of computer processors is mounted within a sealed square enclosure; cooling is implemented by attaching an aluminum heat sink (k-180 w/m"k). the base of the sink has side length of 100 mm, while the 6 fins are of thickness 10 mm, have a pitch (distance between centers) of 18 mm, and length 40 mm. assume the thermal resistance in the base layer is very thin. if cooling is implemented by 20°c water flow through the heat sink at a velocity of 4 m/s, what is the base temperature? when computing average heat transfer coefficient over the fins, one may assume parallel flow over a flat plate. (water properties: k=0.62 w/m"? , p=995 kg/m3, cp=4178 j/kg"k, v=7.73 x 10^-7 m/s)

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

You know the right answer?

An array of computer processors is mounted within a sealed square enclosure; cooling is implemented...

Questions