subject
Engineering, 11.07.2019 03:10 yvette2003

A9-m^3 tank contains nitrogen at 17°c and 600 kpa. some nitrogen is allowed to escape until the pressure in the tank drops to 410 kpa. if the temperature at this point is 15°c, determine the amount of nitrogen that has escaped. the gas constant for nitrogen is 0.2968 kpa-m /kg-k. the amount of nitrogen

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 19:10
Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?
Answers: 3
question
Engineering, 04.07.2019 19:20
Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?
Answers: 1
question
Engineering, 06.07.2019 05:10
The crank case of an automobile is 80 cm long 30 cm wide and 10 cm deep. find out the rate of heat flow from the crank case to the atmosphere when the automobile is moving at 90 km/hr. assume that the vibration of the engine and the chassis iaduce the transition from laminar to turbulent boundary layer may be considered over the entire surface. also find out the drag force on the total surface of the crank case. take the same average convective heat transfer coefficient and average shear stress for front and rare surfaces as for the bottom rnd sides crank case surface temperature is 75°c and atmospheric air temperature is 5 c
Answers: 2
question
Engineering, 06.07.2019 05:20
A)- define powder metallurgy b)- identify the major steps associated with the powder metallurgy process. present the answer in a point format, and include process flowchart. c)- identify two limitations and two advantages of the powder metallurgy process.
Answers: 1
You know the right answer?
A9-m^3 tank contains nitrogen at 17°c and 600 kpa. some nitrogen is allowed to escape until the pres...
Questions
question
Social Studies, 01.10.2019 02:30
Questions on the website: 13722362