Engineering, 17.07.2019 20:30 vaeh41
Acircular steel cylinder of similar external and internal dimension to that in part (a) above, is now made by shrinking a cylinder of external diameter 0.2 m and internal diameter 0.1 m, onto an internal cylinder of similar material with external diameter 0.1 m and internal diameter 0.05 m. determine the radial pressure 'or' at the common surface due to shrinkage alone, so that when there is an internal pressure of 300 mn/m2, the maximum hoop stress σh in the inner cylinder is 150 mn/m2.
Answers: 3
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Acircular steel cylinder of similar external and internal dimension to that in part (a) above, is no...
Biology, 03.08.2019 10:20
Biology, 03.08.2019 10:20
Biology, 03.08.2019 10:20
Geography, 03.08.2019 10:20
Biology, 03.08.2019 10:20
Biology, 03.08.2019 10:20
Physics, 03.08.2019 10:20
Geography, 03.08.2019 10:30
English, 03.08.2019 10:30
Health, 03.08.2019 10:30
History, 03.08.2019 10:30