Engineering, 18.07.2019 05:30 jessicadempsey

For operational safety the design of the aluminium pipe requires that the stress in the pipe wall should not exceed 50% of the yield strength of the material. (i) if the yield strength of the aluminium is 360 mpa and the pipe has a diameter of 1.5 m and a wall thickness of 25 mm, determine the maximum internal pressure the pipe can be allowed to tolerate. (ii) inspection techniques are unable to identify defects due to welding that are less than 1.5 mm long. for the pipe in (i) calculate the minimum fracture toughness of the aluminium that would be needed to accommodate cracks up to this length. (take y = 1.2 for this geometry) (iii) comment on why the fracture toughness value you calculated in (ii) should be higher in practice.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Acarnot refrigerator operates in a room in which the temperature is 21°c and of power when operating. if the food compartment of the refrigerator is consumes 3 kw to be maintained at 2°c, determine (a) the coefficient of performance of the cycle and (b) the rate of heat removal from the food compartment. refrigerator cycle that has a higher coefficient of performance than that of the discussed (e) is it possible to develop a carn ot refrigerator, operating between the same temperature limits? explain

Answers: 2

Answer

You know the right answer?

For operational safety the design of the aluminium pipe requires that the stress in the pipe wall sh...

Questions