Engineering, 18.07.2019 16:20 kennyg02
How would you go about designing for draft on an injection molded part?
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
How would you go about designing for draft on an injection molded part?...
Questions
Mathematics, 16.02.2021 18:30
Chemistry, 16.02.2021 18:30
Mathematics, 16.02.2021 18:30
Mathematics, 16.02.2021 18:30
Medicine, 16.02.2021 18:30
Business, 16.02.2021 18:30
World Languages, 16.02.2021 18:30
Arts, 16.02.2021 18:30
Mathematics, 16.02.2021 18:30
